Ito diesel generator oil how to store?

Ito Power diesel generator drums and canned lubricants should be stored in the warehouse as much as possible to avoid the impact of the climate. The entire packaged lubricant used has to be stored in the warehouse. The barrel is suitable for lying horizontally. Both ends of the barrel must be wedged to prevent rolling. If the bucket is put straight, it is advisable to tilt the bucket slightly so that rain does not collect on the surface of the bucket and the bucket bolt is inundated. Water has an adverse effect on any lubricating oil. In addition, check the drum for leaks and check whether the signs on the barrel are clear.

When taking the oil, the oil drum should be placed on a wooden frame with an appropriate height. The cover of the drum surface should be equipped with a faucet to discharge oil, and a container should be placed under the faucet to prevent splashing, or to put the oil drum directly. The hand pump was inserted into the tubing from the lid to take the oil.

In the case of bulk oil storage tanks, water and dirt are inevitably infiltrated. The condensed water and contaminants concentrate on the bottom of the tank to form a layer of sludge-like substances, and the lubricating oil is thus contaminated. Therefore, the design of the bottom of the tank should be in the shape of a nest or tilt. And need to install a drain cock in order to discharge the dregs on time. When possible, internal tanks should be cleaned on schedule.

Too low or too high temperatures have a bad influence on the lubricating oil, so it is not appropriate to store the lubricating oil in an overheated or overcooled place for a long time.

The lubricating oil drum must be covered and kept clean, washed on time, and wiped with a cloth before use. Funnels and other lubricated vessels require two treatments. Wipe well with cotton, but do not use waste cotton yarns or towels that can easily come off the fibers, because their fibers can be transported from the vessel into the machine and into the lubrication system to block the flow of lubricant.

Each type of lubricating oil should have a special container, and the name of the lubricating oil contained in the container should be specified. If the lubricating oil is barreled, the name and level of the lubricating oil contained in the barrel should be stated on the barrel. Plain. The engine oil can only be marked on the barrel according to the oil grade D or F grade, H grade, and I grade. The plateau oil with lower temperature needs to be marked on the barrel according to the oil product: D grade plateau oil (for cold area) Or F-grade plateau oil (for cold areas), H-level plateau oil (for cold areas), and I-grade plateau oil (for cold areas).

Waste oil or dirt shall be placed in the container indicated until disposal. Be careful to ensure that the waste oil is separated from the new oil so that the new oil is not contaminated.

There should be a record of the amount of all lubricants in the storage room, and each machine should also have a record table in order to check whether all the consumption of lubricating oil is normal. If significant changes are found, the cause should be investigated promptly and analyzed. Oil deterioration or deterioration should be determined as scrap.