How to deal with surface grinder leak failure?

The leakage of surface grinders is the most troublesome problem for many users, but as long as you have mastered the oil leakage causes and judgment methods of surface grinders, and put forward improvement measures, the effect is better after use. General surface grinder leaks, because of the following major problems:

First, the workbench at both ends of the dust-proof plate gold seepage, the general surface grinder assembly is not careful, fixed dust board gold screws through the ends of the rail, direct oil out from the guide rail, the solution is a flat surface grinder screw wound raw tape hit The adhesive went up again.

Second, the adjustment is too large oil, open the rear fuel tank cover, use a flat-head screwdriver to adjust the oil valve switch, clockwise for the small, otherwise large, the size of the general oil control is the first clockwise rotation and then turn One-fourth can be. The groove groove on the guide rail surface grinder is not opened well. It is too shallow or not open. The oil cannot overflow from the side and should be reopened. The oil hole is blocked, the oil is forced out of the guide rail, and the oil hole is blocked. Is the oil is too sticky or dirty, change the oil type or clean the oil, if it is the old surface grinder is generally too dirty guide rails, clean up the oil on it.

Third, before and after the screw leak, if it is a new surface grinder leakage, generally the screw is not installed before and after the retractable sheath, the two screws did not lock or sealant did not play well, if it is the old surface grinder will replace the screw Sheath, re-seal the sealant.

After a failure, we must find the correct reason and the problem will be solved.

Roll Crusher Applications
Roll Crushers are simple in design and construction, long-lasting, economical, and versatile. Roll crushing surfaces operate at a fixed distance apart, as opposed to the continually changing distances in a jaw or Cone Crusher. Product size is much more consistent. Both oversized pieces and fined are minimized. Wet, sticky materials are more easily handled.
The rolls act as flywheels, contributing to smooth operation and efficient use of power. Roll crushers are low in profile and relatively easy to install. They can be fed with a minimum of headroom, or even choke fed. Adjustments are simple. Internal parts are readily accessible.

Typical feed materials for Roll Crushers include: bauxite, cement clinker, chalk, cinders, clay, coal, glass, gypsum, limestone, burnt lime, rock salt, sandstone, shale, sulfur ore, sea shells, and sewer sludge clinker. Single Roll Crushers, sometimes called lump breakers, can also be used for breaking frozen or agglomerated materials.

Roll Crusher

Roll Crusher,Double Roll Crusher,Jaw Roll Crusher,Lab Roll Crusher

Shenyang Sanland Mining Equipment Manufacture Co., Ltd. , https://www.sanlandcrusher.com